Fits Avalon q well! Can pair it to 6inch duct fan or straight to atmosphere from 8 to 6 inch adapter.

It would be nice if the Blockmit could be made to accept 5/64″ sized stamps…these are much easier to find than the 1/8″ stamps. 24MM washers also seem to be somewhat rare… The basic Blockmit jig is a fine idea and well-executed, but perhaps it could be better standardized for North American hardware.

This is a dope piece. Proud owner.

Perfect FIT!

Fit perfectly for my Bitaxe Gamma 601.

Fast Service, and from a local shop. Couldn’t ask for anything better.

Much appreciated CryptoCloaks

Only reason that I don’t give the full 5 stars is because the stamp slot is a liiiiittle tight on some of my stamps. I was 100% able to work through this, but was a tad annoying once you get to about the 15th word. Now, mind you, some of my stamps from the same set were actually a little loose, so a slightly wider slot may be too much for those, but who knows. Still got the job done. Just be sure you get washers that fit flush with the inside diameter of the very base. I’m glad they sent me two because I was an idiot and got washers that fit inside the larger of the 2 diameters and it jacked up both my washers and my jig. Live and learn, baby!